截至11/13號完成：
*SSB settings
*PDCCH settings
when 'carrier band' is changed:
*update 'groupPresense' in SSB settings
when 'carrier scs' is changed:
*update 'scsCommon' in MIB and 'refScs' in TDD-UL-DL-Config-Common
Note: for simplicity, assume scsCommon and refScs equals to scsCarrier.
when 'controlResourceSetZero' is changed:
*validate its value
*validate coreset0 bw against carrier bw
*further validate coreset0/ssb against carrier bw if k_ssb is configured
Considerations on CORESET0/SSB and Carrier BW:
*here, offset is from 38.213 Table 13-1~Table 13-10
*basic assumptions: If offset>0, then 1st RB of CORESET0 aligns with the carrier edge; if offset<=0, then 1st RB of SSB aligns with the carrier edge.
*please refer to the figure below if you are confused:
Further considerations on PDCCH/DCI, CORESET/SearchSpace, PDSCH/PUSCH settings：
*DCIs may be placed in 'PDCCH settings' tab
*need 'BWP tab' to cover: initial ul bwp(as defined in SIB1), initial dl bwp(as defined in SIB1), dedicated ul bwp and dedicated dl bwp. only bwp specific parameters will be included
*need 'initial access tab' to cover: msg1(aka PRACH), msg2(which contains ul grant for msg3), msg3 by rar ul grant, msg4 and its feedback by pucch(as specified in sib1)
*need 'pucch tab' to cover pucch settings(excluding the common pucch configurations from sib1)
*need 'normal pusch tab' to cover normal pusch transmission, including srs, dmrs and possible ul ptrs
*need 'normal pdsch tab' to cover normal pdsch transmissoin, including dmrs and possible dl ptrs, and possible CSI-RS which will be included later.
sib1 tab
---->pdcch(coreset0/css0) defined in separeted PDCCH tab
initial ul bwp tab
---->prach/msg1
---->pucch sib1
---->rar ul grant for msg3 tx
---->msg3 retransmission, assume no msg3 retx
initial dl bwp tab
---->msg2 tab
---->msg4 tab
dedicated dl bwp tab
---->pdcch(coreset1/uss), defined in separated PDCCH tab
---->normal pdsch
dedicated ul bwp tab
---->pucch
---->normal pusch
---->srs