華爲網絡---單臂路由

拓撲結構圖

實驗步驟

第一步:配置R1路由器

<Huawei>sys
[Huawei]sysname R1
[R1]int g0/0/0.10       
[R1-GigabitEthernet0/0/0.10]dot1q termination vid 10  
//封裝dot1q協議，該子接口對應vlan10

[R1-GigabitEthernet0/0/0.10]ip add 192.168.10.1 24   
[R1-GigabitEthernet0/0/0.10]arp broadcast enable     
//開啓arp廣播

[R1-GigabitEthernet0/0/0.10]interface g0/0/0.20
[R1-GigabitEthernet0/0/0.20]dot1q termination vid 20  
[R1-GigabitEthernet0/0/0.20]ip address 192.168.20.1 24
[R1-GigabitEthernet0/0/0.20]arp broadcast enable    

第二步:配置LSW1交換機

<Huawei>sys   
[Huawei]sysname sw1     
[SW1]vlan batch 10 20
//創建vlan10 20

[SW1]int e0/0/1
[SW1-Ethernet0/0/1]port link-type access 
//配置access鏈路

[SW1-Ethernet0/0/1]port default vlan 10
//接口劃入vlan10

[SW1-Ethernet0/0/1]undo shutdown 
[SW1-Ethernet0/0/1]int e0/0/2
[SW1-Ethernet0/0/2]port link-type access 
[SW1-Ethernet0/0/2]port default vlan 20
[SW1-Ethernet0/0/2undo shutdown 
[SW1-Ethernet0/0/2]int g0/0/1
[SW1-GigabitEthernet0/0/1]port link-type trunk
//配置trunk鏈路 

[SW1-GigabitEthernet0/0/1]port trunk allow-pass vlan all
//設置放行所有vlan

[SW1-GigabitEthernet0/0/1]undo sh

第三步:配置PC端IP地址及網關

第四步:測試網絡互聯互通