原创 幀中繼配置路由器子接口配置不上去
[AR1]int Serial 1/0/0.1 ^Error: Wrong parameter found at '^' position.[Huawei-Serial1/0/0]link-protocol f
原创 ipv6鏈路本地地址ping不通
ipv6鏈路本地地址,ping不通。PC的地址也配置了(只需配ipv6的地址,前綴長度64/128都可以,掩碼不用配置。)我是到R1下面粘貼複製過來的ipv6地址,到PC這裏粘貼後,光標移動到下一行了,就ping不通問題就出在這裏,因爲複製
原创 access改hybrid trunk改hybrid
access改hybrid [SW2-Ethernet0/0/3]dis th#interface Ethernet0/0/3 port link-type access port default vlan 10#return[SW2-Et
原创 Error:Too many parameters found at '^' position.
[SW1-Eth-Trunk1]dis th#interface Eth-Trunk1 mode lacp-static max active-linknumber 2#return[SW1-Eth-Trunk1][SW1-GigabitE
原创 vrrp state Initialize
[AR2-GigabitEthernet0/0/0]dis vrrp bTotal:2 Master:0 Backup:0 Non-active:2 VRID State Interface
原创 華爲路由器eNSPAR1220路由器Ethernet口不能添加IP地址
華爲路由器eNSPAR1220路由器Ethernet口不能添加IP地址[R1-Ethernet0/0/0]ip add tab補全不能用,那就不要用Ethernet口,換GigabitEthernet[R1-GigabitEtherne
原创 華爲路由器環回接口配置
華爲路由器環回接口配置[Huawei]interface LoopBack 0[Huawei-LoopBack0]ip address 10.0.2.2 24
原创 Error: Please renew the default configurations.
[SW1-Ethernet0/0/1]dis th #interface Ethernet0/0/1 port link-type trunk port trunk allow-pass vlan 2 to 4094#return[SW1-